89Formulaws6

iTrader: (52)

did these a few days ago with the help of my buddy to do some welding when i got tired. ditched the 3in ory and bullet!

i got the setup off a guy who had it on a cobra, it has a 3.5in x pipe and pipeing as well as 3.5in spintechs with turndowns that are 3.5in

i made it go from the headers 3in to the 3.5 x pipe then 3.5 after tot he mufflers like it was but moved the mufflers a bit.

i thought the 3.5 might be too much for it but seriously its gained quite a bit on the butt dyno

my camera died i'll try and get more pics soon

the drivers side hangs lower because i didn't wanna get too close to the fuel lines, but the passanger of course tucks up nicely


excuse the dirtyness of the car

SsycoticSS

iTrader: (1)

very cool.

Go get er dynoed~!

The Professor

iTrader: (3)

looks like you got some good clearence out of it. how does your low end power feel with them?

89Formulaws6

iTrader: (52)

no low end loss what so ever seriously it prolly has a little more just going by the butt dyno, but i'll get under there and get more pics tomorrow

i love it seriously!!



not bad fabrication for being only 20