Stubborn quick connector...
#1
Teching In
Thread Starter
Join Date: Jan 2007
Location: Southeast OH
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
Stubborn quick connector...
I have just spent an hour fighting the white plastic ring on the quick disconnect of the clutch master cylinder to the tranny case. This write-up I found in the sticky says to use two screw drivers to press the white cup toward the tranny and it just pops off. Hah!
Step number nine:
http://www.installuniversity.com/ins...r_cylinder.htm
Are there any tools or special tricks or do I need to just keep fighting it until it finally pops loose?
Thanks!
Step number nine:
http://www.installuniversity.com/ins...r_cylinder.htm
Are there any tools or special tricks or do I need to just keep fighting it until it finally pops loose?
Thanks!
Last edited by Widetracker; 09-05-2007 at 06:37 PM.