What is too low for O2 millivolts?
06-26-2003, 10:59 AM
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Feb 2002
Location: N. Ft. Myers
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
What is too low for O2 millivolts? On Scanmaster I like to run around .900. However, sometimes I see it dip down into mid to lower .800's. I was wonder around what millivolts is way too lean? Where do most people run?
06-27-2003, 01:59 PM
#2
Re: What is too low for O2 millivolts? I assume you are talking about WOT readings in PE mode . . . the acceptable range is supposed to be 875-910mv. They should average out to 890mv for max hp. So anything less than 875mv would be considered to be too lean.
