almost free LS1
#1
TECH Apprentice
Thread Starter
iTrader: (4)
Join Date: May 2006
Location: Kenefick, tx
Posts: 378
Likes: 0
Received 0 Likes
on
0 Posts
almost free LS1
I will be picking up an LS1 this weekend it has been out side for a couple of months.. It was tarped but it was ripped up when i saw it... The headers where gone so im sure water has gottin in there .........What would you do to check this motor out????
#4
Launching!
iTrader: (5)
Join Date: Oct 2007
Location: Swift Current, Saskatchewan, Canada
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Wow can't go wrong with that! Deffinantly take it to a machine shop and have them check it out. If not; do a compression test, pull the oil pan, and I would pull the tappet covers at least just to have a look. Oh and a Gasket/Seal set obviously wouldn't be a bad idea as they can be a real p.i.t.a afterwords! Good Luck Bro!
#5
have a machine shop look at it f-t-w,
if your asking that question, have a more mechanically inclined friend look at it with you. (not saying your not, dont take it the wrong way, but even if you are everyone has that one friend whos an engine GOD...bring him )
after that gaskets&seals, new rings and berrings like previously stated . after that, go nuts on it...500+ before the juice. jk, but seriously...
What would you do to check this motor out????
after that gaskets&seals, new rings and berrings like previously stated . after that, go nuts on it...500+ before the juice. jk, but seriously...