I changed out my valve springs and...
04-05-2008, 11:52 AM
#1
Launching!
Thread Starter
iTrader: (5)
Join Date: Sep 2007
Location: Lexington, SC
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
I changed out my valve springs and... It wasnt all that hard. I used the crane cams valve spring tool because that was whats everyone on here recommended. I ran into a few snags though. As I was going to put a retainer on one of the two springs I was about to compress I dropped it. Of all places that bitch rolled into the openings behind the head bolts. 
. I seriously thought that i was screwed. Somehow my buddy Ricky got it out. Needless to say I owe him dinner. The job took all day as I did take a lot of breaks. I replaced the old 918s with the new revised 918s becasue I had busted one, didnt drop the valve. While I was at it I also paited the valve covers and the coil pack brackets red. It looks really good. The best tool anyone can use for this project is the crane tool without a doubt. 
to crane cams
. I seriously thought that i was screwed. Somehow my buddy Ricky got it out. Needless to say I owe him dinner. The job took all day as I did take a lot of breaks. I replaced the old 918s with the new revised 918s becasue I had busted one, didnt drop the valve. While I was at it I also paited the valve covers and the coil pack brackets red. It looks really good. The best tool anyone can use for this project is the crane tool without a doubt. to crane cams 
