to deck or not to deck.... that is the question
#1
to deck or not to deck.... that is the question
I know this is the forced induction section, but since I'm building a low compression motor i thought i would start here.
I know its hard to tell by pictures, I'm just trying to have an idea before i take my 6.0 to the machine shop what you guys thought. Here are some pics. you can see where the gasket was sitting, it does have a couple thousandths you can hardly feel and i didn't know whether this was something to be concerned about or not
I know its hard to tell by pictures, I'm just trying to have an idea before i take my 6.0 to the machine shop what you guys thought. Here are some pics. you can see where the gasket was sitting, it does have a couple thousandths you can hardly feel and i didn't know whether this was something to be concerned about or not
Last edited by fitz98ta; 05-01-2008 at 02:11 PM.