Anyone who has painted the front bumper support
09-09-2003, 01:04 AM
#1
TECH Resident
Thread Starter
iTrader: (1)
Join Date: Feb 2002
Location: Illinois
Posts: 865
Likes: 0
Received 0 Likes
on
0 Posts
Anyone who has painted the front bumper support Did you have rivets in your nose piece holding it to the grayish bumper support? I have two rivets in the center, one on the passenger side and none under the connector on the driver's side.
09-09-2003, 08:22 AM
#4
Re: Anyone who has painted the front bumper support No, but that may be courtesy of SLP. Your nose piece has been modified by SLP to align with the hood.
Looking at the hole for the plastic pin, I'd say you'd be safe drilling out the small metal rivits, and not worry about how things line up.
SLP more than likey puts the rivits in to make sure the nose does not move and aligns with their hood. One could always replace the rivits too.
Looking at the hole for the plastic pin, I'd say you'd be safe drilling out the small metal rivits, and not worry about how things line up.
SLP more than likey puts the rivits in to make sure the nose does not move and aligns with their hood. One could always replace the rivits too.
09-09-2003, 11:17 AM
#6
On The Tree
Join Date: Dec 2001
Location: Louisville, KY
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
Re: Anyone who has painted the front bumper support Mine had it. It's a Firehawk thing 
I drilled it out, then replaced it with a screw when I put it back together.
Here's a pic of my engine bay showing the painted support:
I drilled it out, then replaced it with a screw when I put it back together.Here's a pic of my engine bay showing the painted support: