SexyTransAm

iTrader: (6)

iv been thinkin bout doin this for some time now. its a 95 TA obd1 so it has only the one o2 on it and its in the drivers side bank. so there is no way it can read what is comin out the other side. im thinkin bout gettin a o2 ext and puttin in right befor the cat in the y pipe so it can get a reading from both sides. any input on this (good or bad) would be great!!!

96lt1m6

iTrader: (31)

should have 2 o2 sensors 1 drivers side 1 pass side.
you should look closer at the drivers manifold & pipe area i am sure it has an o2 sensor that you cannot see and i am positive the harness is there (flat 4-pin connector)

sweetbmxrider

iTrader: (13)

sounds like a great idea /sarcasm

ss.slp.ls1

iTrader: (36)

OBD1 has one pair (2) of pre-cat o2 sensors. OBD2 has 2 pairs (4) of o2 sensors. One on each manifold before the cat, one after each cat.

SexyTransAm

iTrader: (6)

oh ok i just looked at all data and the reason i didne see it was cause its on top the started. so i may look into puttin puttin a wide band o2 befor the cat