ale76051

iTrader: (2)

I had my heads and intake all ported and prettied up a couple months ago. I'm thinking about spraying the car but I noticed a pic of the heads, which I didn't catch prior. But goin down the runner right before the valve is a small spot of j-b weld which I asked the guy who ported it and he said that he cut though into the other runner. It doesn't look to be that bad and the car has ran great the last couple of months with exception to the rain. Some reason the picture won't upload on here, but it is smaller than an airsoft BB. Should this give me any problem if I do spray it?

Thanks, Adam

gregrob

iTrader: (8)

I would let it rip..

ale76051

iTrader: (2)

Sweet thanks

qc97z

iTrader: (9)

As long as it's sealed up, you should be good....but, if it dislodges and ends up in the valvetrain or in the cylinder...could be painful.

ale76051

iTrader: (2)

I mean it's been good for now, but what amount of pressure increase will there be in the intake while sprayin

speedracer2536

iTrader: (15)

You wont have an issue.