blakez28

iTrader: (6)

My power leather seats are starting to show their age. The passenger side is completely torn on the bottom and the inside has turned hard after drying out. The driver's seat has a tear where the seatbelt connects. Potentially unsafe in an accident because the belt will probably slide up and be on my neck.

I've been looking at LS1 seats. I think they look better (black leather), and would look tastefull in my already black interior. Would I need anything to install 98+ seats into my 95 z28? I'm pretty sure the brackets are the same, but what issues would i run into when trying to wire the power?
Driver side is power, while passenger is manuel. Not sure if it's the same for LS1's

Any insight would be greatly appreciated.

defaultexistence

iTrader: (11)

They will bolt right in

blakez28

iTrader: (6)

Anything I need to know concerning the power driver seat?

jaycenk

iTrader: (1)

It just needs power. If the connectors are not the same (I don't know for a fact if they are or not) just cut the end off yours and splice it on to the new seat.

sweetbmxrider

iTrader: (13)

Connectors are the same, it literally is bolt in, plug in, and play.....in?

blakez28

iTrader: (6)

That's what I was hoping to hear. Thanks for the help guys

Marc3.4V6

iTrader: (1)

Did this myself, x2 on connectors being the same. I actually did the entire interior except for the dash.