Thinking about porting my own heads...
#1
TECH Fanatic
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Charleston, S.C.
Posts: 1,213
Likes: 0
Received 0 Likes
on
0 Posts
Thinking about porting my own heads...
The motor is going to be apart again here soon to get the bottom end rebuilt and i was thinking about giving it a shot while i have it apart. I figure any free HP is good. I do plan on getting some worked over by AI sometime next year.
Does anyone have any advise or a write up or something?
Does anyone have any advise or a write up or something?
#4
TECH Enthusiast
Join Date: Jul 2006
Location: San Diego
Posts: 638
Likes: 0
Received 0 Likes
on
0 Posts
Porting can be touchy. I've seen lots of amatuer botch jobs, be careful. And remember, don't lower the floor. If, you don't know what that means, have a profesional port them.
#5
TECH Fanatic
Thread Starter
iTrader: (6)
Join Date: Aug 2006
Location: Charleston, S.C.
Posts: 1,213
Likes: 0
Received 0 Likes
on
0 Posts
Yeah i know that much. Like i said i plan on getting some done next year. I would really like to get some free HP out of the heads since i have some time to try and port them. Im not expecting much and im not going to go crazy and port the hell out of them. Just a little something extra you know.