fidanza 4.3 clutch question

Reply Subscribe

Thread Tools

Search this Thread

10-27-2008, 12:52 PM

fortmyerspolice

TECH Resident

Thread Starter

iTrader: (7)

Join Date: Jun 2006

Location: Fort Myers FL

Posts: 908

Likes: 0

Received 0 Likes on 0 Posts

fidanza 4.3 clutch question

Just wondering if I should use the pilot bearing that came with this kit and that piece thats on the bottom pic, I guess it goes on the input shaft.

Reply Like

10-27-2008, 02:31 PM

fortmyerspolice

TECH Resident

Thread Starter

iTrader: (7)

Join Date: Jun 2006

Location: Fort Myers FL

Posts: 908

Likes: 0

Received 0 Likes on 0 Posts

Is it a slave shim??

Reply Like

10-28-2008, 11:28 AM

fortmyerspolice

TECH Resident

Thread Starter

iTrader: (7)

Join Date: Jun 2006

Location: Fort Myers FL

Posts: 908

Likes: 0

Received 0 Likes on 0 Posts

So should I use this thing or not? I am getting a Tick adj. master btw.

Reply Like

10-29-2008, 09:43 PM

DJB

12 Second club

iTrader: (15)

Join Date: Mar 2005

Posts: 167

Likes: 1

Received 0 Likes on 0 Posts

Thats the throwout bearing and it goes on the slave. So if you are reusing your slave then pop the old throwout off and install the new one thats in your hand.

Reply Like

10-29-2008, 09:51 PM

fortmyerspolice

TECH Resident

Thread Starter

iTrader: (7)

Join Date: Jun 2006

Location: Fort Myers FL

Posts: 908

Likes: 0

Received 0 Likes on 0 Posts

well im getting a new one, but should i pop the throwout bearing off the new one and put the fidanza one in?

Reply Like

10-29-2008, 10:05 PM

DJB

12 Second club

iTrader: (15)

Join Date: Mar 2005

Posts: 167

Likes: 1

Received 0 Likes on 0 Posts

No, the one that comes on the slave will be the same. Just sell or save the throwout bearing from the Fidanza kit.

Reply Like

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last