Tips for master cylinder removal
10-06-2009, 12:15 AM
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: Nov 2004
Location: Michigan (Macomb or Lansing)
Posts: 1,653
Likes: 0
Received 0 Likes
on
0 Posts
Tips for master cylinder removal I need to put a new hose from my master to slave cylinder. Its pretty easy, but i always have a hard time getting the master cylinder in and out.
Any tips on this?
The last two times i did it i had the entire engine out once and the other time i had a header off and the trans off.
I just see it being a problem getting to it.
Any tips on this?
The last two times i did it i had the entire engine out once and the other time i had a header off and the trans off.
I just see it being a problem getting to it.
10-06-2009, 03:42 AM
#2
Getting everything possible out of your way, and if your arms are anywhere near the size of mine, get ready for some pain/strange maneuvering.
Be patient most of all, I just got done pulling mine out to bench bleed it. No matter how many times you've done it, it's never easy.
Be patient most of all, I just got done pulling mine out to bench bleed it. No matter how many times you've done it, it's never easy.