Ram 7.25 Twin Disc Clutch
02-02-2010, 02:44 PM
#2
I'm assuming this is for a road racing (or similar) application? I don't think many here will have had experience, but you might scroll down a few sections to the Road Racing and Auto-X section...if anyone has experience with it, they would probably be posting in there.
02-03-2010, 07:56 AM
#3
Teching In
Thread Starter
Join Date: Dec 2008
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, it's for a 2400lb LS1 powered race car. Not really concerned about driveability but I contacted RAM themselves and there seems to be a lot of work involved to make the clutch work. They don't sell a bolt in kit for the 7.25" clutch, you have to piece together the bearing/housing/flex plate etc. so I was wondering if anyone had successfully installed one on an LS motor.
