RS777

iTrader: (1)

Sorry for the newb question, but my pullout (02 camaro ss) came with what looks like the slave cylinder line cut off. The plug pops out of the port, but I was wondering if anyone knows what to replace this with? Does anyone sell this line/plug by itself or do I have to go buy another slave cylinder with everything attached? While its sitting here I'd rather buy a nice piece, but just curious. I am trying to figure out if I need to have a custom line made or if GM or Aftermarket sells something to replace all of this. I went through the FAQ and didn't see anything on this. Just trying to see if I am going to have to replace my slave cylinder or not.

Secondly and I know this is a can of worms, but what would you recommend for transmission fluid or just go with the DEXRON III?

Thanks for your help!

jmd

iTrader: (4)

that's just a stock master to slave cylinder line.

For aftermarket, check Tick Perf --->

As for fluid, I go w/ Dex III. Lots of opinionated threads on this topic already.

RS777

iTrader: (1)

Thank you for the info, so even though I popped it out, I can get a new one and it should be good/pop back in? Thanks again!

jeeperanthony

iTrader: (1)

Also check your local hydraulic shop. I just had one built for $30.

RS777

iTrader: (1)

Even better thanks! I see that aeroquip or someone makes an OEM to -4AN adapter so that should be cake to do. Thanks everyone!

HavATampa

iTrader: (49)

I'm confused. Are you thinking what you have in the picture is broke? If so, it's not.