Ryant10275

iTrader: (1)

I'm having a problem figuring out the shift rails on my reassembly of my t56. I can see how the 1/2 and 3/4 go but I'm having a problem figuring out connecting the other rail. I can get it hooked up but then it's barely sitting in the hole on the face plate. Can anyone help or have pictures to show me? Sorry for punctuation this is typed on my phone while in the garage. Thanks in advance.

jmm98LS1

iTrader: (28)

The 5/6/R rail doesn't sit very deep in the front plate. You have to lift up on it quite a bit to get it on the interlock plate on the main rail....you're probably doing it right.

Ryant10275

iTrader: (1)

Ok thanks I looked up a few pictures and it seemed right but I just kept thinking the rail needed to sit in the whole way. Thanks!