LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Mity Vac clutch bleeding ?

Thread Tools
 
Search this Thread
 
Old 01-20-2006, 06:34 PM
  #1  
TECH Junkie
Thread Starter
iTrader: (50)
 
oange ss's Avatar
 
Join Date: Jan 2005
Location: Texas
Posts: 3,229
Likes: 0
Received 5 Likes on 4 Posts

Default Mity Vac clutch bleeding ?
how are yall doin it ? I cant seem to get a good seal tryin all the misc fittings in the kit...TIA
oange ss is offline  
Reply Like
Old 01-29-2006, 10:05 AM
  #2  
TECH Apprentice
iTrader: (168)
 
Farmer2's Avatar
 
Join Date: Jul 2002
Location: Chicago Far Far South Subs
Posts: 359
Likes: 0
Received 0 Likes on 0 Posts

Default
I made a rubber gasket to go in place of the factory long rubber one and then drilled the vent hole in the factory cover to 1/8". The smaller fittings will then fit snug in the 1/8" hole.
Farmer2 is offline  
Reply Like
Old 01-29-2006, 03:25 PM
  #3  
TECH Junkie
Thread Starter
iTrader: (50)
 
oange ss's Avatar
 
Join Date: Jan 2005
Location: Texas
Posts: 3,229
Likes: 0
Received 5 Likes on 4 Posts

Default
gasket ?
oange ss is offline  
Reply Like
Old 01-29-2006, 04:02 PM
  #4  
TECH Apprentice
iTrader: (168)
 
Farmer2's Avatar
 
Join Date: Jul 2002
Location: Chicago Far Far South Subs
Posts: 359
Likes: 0
Received 0 Likes on 0 Posts

Default
Originally Posted by oange ss
gasket ?
It will go under the cover basically where the factory one goes.
Yours has no diaphram/gasket
Farmer2 is offline  
Reply Like
Old 01-29-2006, 04:08 PM
  #5  
TECH Junkie
Thread Starter
iTrader: (50)
 
oange ss's Avatar
 
Join Date: Jan 2005
Location: Texas
Posts: 3,229
Likes: 0
Received 5 Likes on 4 Posts

Default
on the Mity Vac ?
oange ss is offline  
Reply Like
Old 01-29-2006, 04:12 PM
  #6  
TECH Apprentice
iTrader: (168)
 
Farmer2's Avatar
 
Join Date: Jul 2002
Location: Chicago Far Far South Subs
Posts: 359
Likes: 0
Received 0 Likes on 0 Posts

Default
under the "factory" master cylinder res cover
Farmer2 is offline  
Reply Like
Old 01-30-2006, 12:58 PM
  #7  
TECH Junkie
Thread Starter
iTrader: (50)
 
oange ss's Avatar
 
Join Date: Jan 2005
Location: Texas
Posts: 3,229
Likes: 0
Received 5 Likes on 4 Posts

Default
I was talkin about using the vac pump on the slave
oange ss is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
Just installed a SPEC II problems!!!




Advanced Search

All times are GMT -5. The time now is 03:06 AM.