BlackZLS1

iTrader: (5)

Recently i had a new clutch set installed along with a new slave cylinder. it is a step up from stock set up ("high-performance replacement" from a local parts store). It grabs hard and has great driveablilty but the engagement has been closer to the floor since my ram hd. and now as the clutch gets broke in farther, it seems like it isnt fully disengaging. So im going to shim it and re-bleed it but i dont have a shim. Does anyone on here have one they could part with? or where can i buy one for a reasonable cost. i had one with my ram hd but ive lost it. im thinkin one like the 1/4 inch one from the ram would work fine but im not sure.