Clutch master install problem
06-04-2007, 02:47 PM
#1
Teching In
Thread Starter
Join Date: Feb 2007
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Clutch master install problem Is there a special way to install that quick connect line from the master into the slave, or do you just jam it in? I'm having real issues and i can't get it to stay in! Its a 98 z28 m6.
06-04-2007, 09:24 PM
#3
TECH Apprentice
iTrader: (16)
Join Date: Jan 2006
Location: Tulsa OK
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
It just pushes in. Make sure the little plastic release ring is up on it the way it is supposed to be before you push it in to release it.
I had some issues with my tranny a month or so ago that made me have it in and out twice. The first time I had tons of trouble putting that thing in, my buddy came over and pushed it in like I was retarded
. I don't know if I was too gentle or hands were just too greasy to push hard. Second install it pushed in real easy like I'd done it before 
I had some issues with my tranny a month or so ago that made me have it in and out twice. The first time I had tons of trouble putting that thing in, my buddy came over and pushed it in like I was retarded
. I don't know if I was too gentle or hands were just too greasy to push hard. Second install it pushed in real easy like I'd done it before 
. I tried for 15 mins the other night to no avail w/e its done now 
