soontobeLS1

Well, I have been having the sticking clutch pedal problem. I have done the drill mod and bleed.

I was just thinking about the year of the master cylinder etc. My car is a 2001. However, my ASC build date is Oct 11, 2000. Perhaps I didn't get the upgraded hydraulics????? If that is the case, then I need to buy an upgraded factory unit. Can anybody shed some light on this and say this is the problem.

Thx.

Hope somebody is in the know.

brad8266

iTrader: (23)

Its possible that the master is wore out. You could try a new one but it also could be the clutch as well. How many miles are on the clutch?

soontobeLS1

31,000 Miles on the clutch.

brad8266

iTrader: (23)

The clutch should be OK then, failing master is possible and is the easiest thing to replace.

bowtieman81

iTrader: (35)

Look on the bottom of the master cylinder cap, it will have 2 digits in the middle of the cap with a circle around them. That is the year of your master cylinder.

soontobeLS1

I will check under the cap....will let ya know soon!

soontobeLS1

So, I checked the cap on my clutch fluid resovoir...it says 00, so I assume that I dont have the upgraded master clylinder then.