installing the oz700 this weekend
#1
Launching!
Thread Starter
Join Date: Jan 2007
Location: Beaufort, Sc/ Roswell, Ga
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
installing the oz700 this weekend
My clutch **** out on me recently and i wasn't sure if it was the slave or master, so I figured instead of replacing one, I just decided on replacing everything. I got a new master cylinder, slave cylinder, and the textralia. I tired to get a pre-bled master cylinder with reservoir but the dealership near me is a bunch of ******, so now I'm gonna have to bench bleed the new one. Any tips on the overall install? I don't think my new clutch came with all the torquing measurements, are they the same as stock? If anyone has any advice I'd appreciate it. I'm looking forward to actually getting my power to the ground