K- member Help!!
08-10-2004, 02:46 PM
#1
Staging Lane
Thread Starter
Join Date: Jun 2004
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
K- member Help!! I just got through putting in my flowtech headers. I have now realized that I didn't shave the K-member. 
I checked it and there is only about 1 cm between the header and K-member. Is this ok, or should I take the headers off and shave it down.
I checked it and there is only about 1 cm between the header and K-member. Is this ok, or should I take the headers off and shave it down. 
08-10-2004, 03:08 PM
#2
TECH Addict
iTrader: (13)
Join Date: Jan 2004
Location: USN, Haze Grey and Underway
Posts: 2,900
Likes: 0
Received 1 Like
on
1 Post
Originally Posted by transam02
I just got through putting in my flowtech headers. I have now realized that I didn't shave the K-member. I checked it and there is only about 1 cm between the header and K-member. Is this ok, or should I take the headers off and shave it down.
I checked it and there is only about 1 cm between the header and K-member. Is this ok, or should I take the headers off and shave it down.However, I was able to notch the k-member without removing the header. I had an air saw though..
