Notices
Parts Classifieds This an archive of the older parts classifieds, please create a new listing in our Marketplace.
Sponsored by:
Sponsored by:
Parts Search
Keyword:

Category:

Price:

Part Fits:










Location (State):

Item Condition:

Engine:






LS Engine?:



Cars Search
Keyword:

Year:
(Range)

Make:

Model:

Price:

Mileage:

Private or Dealer Listing:

Location (State):

Color:

Transmission:

Drivetrain:

LS Engine?:

FS: CMS Forged 347 LS1 - 44x rwhp/41x rwtq SoCal

Thread Tools
 
Search this Thread
 
Old 03-29-2012, 03:49 AM
  #1  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default FS: CMS Forged 347 LS1 - 44x rwhp/41x rwtq SoCal

Category: Engine - Complete Motors
Price: $6500
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): CA
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine

Hey All,

Update! I will pay shipping, up to $500 freight fee. Above $500 will be buyer's responsibility.

I am selling the entire motor, including the NW 102mm throttle body, including the Fbody ls1 harness. Asking price is $6500 for it all.


Unfortunately, I was in an accident with my SS and it was totalled. I'm selling the complete motor and the F body Ls1 harness. The collision involved the rear end and driver's side. The front of the car had no direct impact.

The block is an aluminum LS1 from a 2000 Vette. There are less than 4000 miles on this rebuilt, forged motor. It was broken in before it was taken to the track.

This combination put down 443 rwhp/ 417 rwtq through an m6/ls7 clutch, stock 10 bolt rear end with 3.42 gears (this was fresh out of the rebuild.. .numbers are likely higher after being broken in). In an 02 SS, approx 3450-3500 race weight, street tires, this combo ran a best of 11.5 @ 123.5 mph at Famoso (back-to-back-to-back 11.5 passes), with low 1.8 60' times. Best pass at Fontana (RIP) was 11.7 @ 120 mph. This motor would go 11.1-11.2 easily with a properly setup rearend in an avg weight f body. On top of that, this motor is ready for a 200-250 shot! This motor has never seen nitrous or any type of forced induction.

Specs:
Block: Aluminum 347 ci Ls1, built by CMS (callies compstar rods, Wiseco pistons) 10.8:1 compression
Cylinder Heads:Tims Porting Ported 853 heads , rebuilt, bead blasted, hot tanked, 3 angle valve job by richard at WCCH, 60cc chambers
Cam: CMS Custom 231-235 on a 112+2 (cam is degreed on a 110 intake centerline)
Intake: Fast 102 intake, ported by Vengeance racing, with 36 pph injectors. Nick Williams 102mm throttle body.


Ryne/Mike/Mike at CMS can vouch for everything I said and the specs of the motor. Anyone who knows CMS knows they they know their **** and they don't half-*** their builds. This is a stout stock ci LS1 motor and is a testimony to the ability of the 'little old LS1".

Throw this engine into your f body and have a low 11 second daily driver, mid -low 10's if you go with nitrous!


http://www.youtube.com/watch?v=WS_qFeJaehk
Attached Thumbnails FS: CMS Forged 347 LS1 - 44x rwhp/41x rwtq SoCal-cms-347-dyno-sheet.jpg  

Last edited by glhs422; 04-07-2012 at 05:53 PM.
Old 03-29-2012, 10:00 AM
  #2  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Here's a video of the 11.5 run...

http://www.youtube.com/watch?v=3bcvKETwJ8Y
Old 04-02-2012, 12:19 PM
  #3  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Bump!
Old 04-03-2012, 11:13 AM
  #4  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Bumpity bump.
Old 04-04-2012, 12:31 PM
  #5  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Bump for the almighty LS1.
Old 04-05-2012, 05:12 PM
  #6  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Bump! Still for sale... intake to oil pan, including the Fbody LS1 harness.
Old 04-06-2012, 01:08 PM
  #7  
On The Tree
iTrader: (4)
 
Bradlyj8Z28's Avatar
 
Join Date: Jan 2008
Location: Fresno, CA
Posts: 144
Likes: 0
Received 0 Likes on 0 Posts

Default

Negotiable at all? Location?
Old 04-06-2012, 01:22 PM
  #8  
11 Second Club
Thread Starter
iTrader: (4)
 
glhs422's Avatar
 
Join Date: Feb 2005
Location: So. Cal
Posts: 175
Likes: 0
Received 0 Likes on 0 Posts

Default

Originally Posted by Bradlyj8Z28
Negotiable at all? Location?
The motor is currently in Murrieta, CA.

The price is 'or best offer'.




All times are GMT -5. The time now is 10:03 PM.