9" rear end housing and axles Trick Chassis
#1
FormerVendor
Thread Starter
iTrader: (8)
Join Date: Oct 2006
Location: WI
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
9" rear end housing and axles Trick Chassis
Category: Accessories
Price: $1140
Location (State): WI
Item Condition: Brand New
LS Engine?: Fits LS Engine
FILL AND DRAIN (STANDARD)
Brand new center housing can (STANDARD)
4 lower control arm mounting holes (STANDARD)
3" .250 wall axle tubes (STANDARD)
Internal axle tube gussets (STANDARD)
Fits aftermarket torque arm's
Torque arm bracket is included
Your choice 31 or 35 spline STRANGE ENGINEERING axles wheel studs and bearing
LS1 OR LT1 stock brakes will fit!
All the above is $1140
We also sell center sections!!
This can be a fully assembled unit
Brake lines
Powdercoating
E brake
ABS 4 channel available
5/8" stud up grade
Gun drilled axles
40 spline axle's available
Back bracing available
Anti roll bar setups
Aftermarket brakes
Message me or post your questions
Shop phone number 608-313-9197
Info@trickchassis.com
Check them out on the website
Trick Chassis 9" setups
Trending Topics
#9
TECH Enthusiast
iTrader: (5)
Mine fit great. Back braced, 35 spline, stock width, 5/8 studs, Strange actually dual drilled the flanges for 5/8 studs and stock .509 knurl. My rear was nearly dead centered when swapping in the new rear from the stock unit that was centered previously. Same deal on front to back location. It did come with the center section studs already pressed in, however just for myself I swapped to ARP. There was nothing wrong with the studs in it and he was straight foward that they were Dorman brand. I did also add T-bolts to the order. The swaybar mounts are included as well and on the money compared to stock spacing. I did add 2 tabs for the hard brake lines and welded one nut for the brake line bracket. Here is my thread, I need some updated installed pics: https://ls1tech.com/forums/gears-axl...y-got-9-a.html
The gentlemen that runs the company was exceptional to deal with. Always answered the phone and was pleasant answering questions. Very nice piece. Great packaging and turn around time. I would absolutely deal with this company again.
The gentlemen that runs the company was exceptional to deal with. Always answered the phone and was pleasant answering questions. Very nice piece. Great packaging and turn around time. I would absolutely deal with this company again.
#10
#13
FormerVendor
Thread Starter
iTrader: (8)
Join Date: Oct 2006
Location: WI
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
Center sections Trick Chassis
#16
TECH Apprentice
iTrader: (11)
Correct if using a PG/TB400 longer.
6 speed will require shorter.
Either way will require modification to driveshaft. Not trying to Discourage anyone, rather just educating on what is required to make the changeover as painless as possible.
Last edited by brobinson216; 01-28-2016 at 12:00 PM.