Wagner CNC Ported 243 Castings with ARP Stud Kit
#1
Teching In
Thread Starter
Join Date: Dec 2015
Location: Connecticut
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Wagner CNC Ported 243 Castings with ARP Stud Kit
Category: Accessories
Price: $1100
Location (State): CT
Item Condition: Used
Engine: LS1/LS6
LS Engine?: Fits LS Engine
I have a set of used Wegner CNC ported 243 castings. I purchased these from a local guy a few months ago, and planned to run them on my C5 Z06. However, I never got to installing them over the winter due to a house project that takes precedent.
I was told they have Del West Ti intake valves, however I have not pulled them out to verify this. I was also told the springs are .650 PAC beehive springs, but have not verified this either. I was told they have around 5,000 miles on them. I tried to clean one of the chambers a bit, and most of the carbon comes off with some simple green and a toothbrush. I visually checked the threads and none appear to be stripped out or damaged. I also have a set of ARP head studs to go with them for pre 2004 blocks
Looking for $1100 for everything. I would be willing to ship if the buyer chips in.
Last edited by RideRed0331; 04-02-2016 at 03:57 PM.
#2
Teching In
Thread Starter
Join Date: Dec 2015
Location: Connecticut
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
I received a PM regarding chamber size. I bought a measuring syringe from pep boys for adding oil to gas for 2-stroke engines, and checked them as best as I could...
I did the same test twice and ended with 62cc chambers both times. Given my method I would say this is probably accurate within 1cc, but I recommend a pro check them to be positive.
I also received a message that the Barcode on each port probably signifies a NASCAR spec head, which Wegner did build.
Please feel free to PM with any further questions!
I did the same test twice and ended with 62cc chambers both times. Given my method I would say this is probably accurate within 1cc, but I recommend a pro check them to be positive.
I also received a message that the Barcode on each port probably signifies a NASCAR spec head, which Wegner did build.
Please feel free to PM with any further questions!