Turbo Kit 76mm + that keeps A/C
#1
On The Tree
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Fort Lewis, Washington
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
Turbo Kit 76mm + that keeps A/C
Would prefer a front mount system that keeps the AC. 76mm, however I would prefer a 80 or an 88mm minimum unless its a twin turbo setup. If twin turbos are the case Im looking for a PT62mm setup.
Rear mount is still a possibility, just PM me what you have.
Keep in mind its going on a 408, so if you know the turbo is WAAAAAY to small for the engine, please don't PM me because more likely than not I will not be interested.
Thanks in advance, you can respond here or PM me, whichever you prefer.
Rear mount is still a possibility, just PM me what you have.
Keep in mind its going on a 408, so if you know the turbo is WAAAAAY to small for the engine, please don't PM me because more likely than not I will not be interested.
Thanks in advance, you can respond here or PM me, whichever you prefer.
Last edited by Wellz; 06-15-2010 at 06:42 PM.
#4
I am thinking of selling my kit not installed yet PM me
Garrett GT42 77mm turbo
4" downpipe off of turbo
4" to 3" reducer on downpipe all the way back to the intermediate pipe
Turbonetics wastegate w/3 seperate springs
V-band connections w/clamps
Braided steel oil retun line w/-10 AN fittings
Braided steel oil feed line w/-6 AN fittings
NPT -> -AN fitting for LT1 block (oil feed connection)
Milodon LT1 oil pan w/-AN oil return fitting (Milodon part number 30909)
Aluminum cold side piping (3")
3-core FMIC
JGS BOV
Silicon couplings w/T-bolt clamps
MAF sensor (pressure side)
AEM boost controller w/all vacuum lines and fittings (instruction manual included)
Autometer boost guage
Mototron 60# injectors
Garrett GT42 77mm turbo
4" downpipe off of turbo
4" to 3" reducer on downpipe all the way back to the intermediate pipe
Turbonetics wastegate w/3 seperate springs
V-band connections w/clamps
Braided steel oil retun line w/-10 AN fittings
Braided steel oil feed line w/-6 AN fittings
NPT -> -AN fitting for LT1 block (oil feed connection)
Milodon LT1 oil pan w/-AN oil return fitting (Milodon part number 30909)
Aluminum cold side piping (3")
3-core FMIC
JGS BOV
Silicon couplings w/T-bolt clamps
MAF sensor (pressure side)
AEM boost controller w/all vacuum lines and fittings (instruction manual included)
Autometer boost guage
Mototron 60# injectors