WTB: coilpacs and camshaft and PCM/Harness
#1
TECH Fanatic
Thread Starter
iTrader: (25)
Join Date: Dec 2004
Location: Houston, TX
Posts: 1,826
Likes: 0
Received 0 Likes
on
0 Posts
WTB: coilpacs and camshaft and PCM/Harness
I'm looking for some truck or car coilpacs. stockers are fine, they just need to work fine and be a full set.
im also looking for a broken genIII camshaft. must have the rearend of the shaft with the cam position sensing unit still intact on the camshaft (dont need the cam pos. sensor, just the cam). any genIII cam will work fine, but i'd prefer to get a lq9 truck cam of any year
also, im looking for a truck PCM/harness 2005 or earlier. an LS1 harness would be sufficient as well. harness and pcm must match.
any comments/suggestions/deals please pm me or email me at jake@brownlures.com or jakebdb56@aol.com
thanks
im also looking for a broken genIII camshaft. must have the rearend of the shaft with the cam position sensing unit still intact on the camshaft (dont need the cam pos. sensor, just the cam). any genIII cam will work fine, but i'd prefer to get a lq9 truck cam of any year
also, im looking for a truck PCM/harness 2005 or earlier. an LS1 harness would be sufficient as well. harness and pcm must match.
any comments/suggestions/deals please pm me or email me at jake@brownlures.com or jakebdb56@aol.com
thanks
#5
TECH Enthusiast
iTrader: (37)
I have a 2003 truck harness that may work for you:
Wire harness pic 2003 LM7 (5.3) wiring harness $50
The plug for the crank sensor was cut off but is included. There are a bunch of wires that were cut (looks like they went to the fuse panel). One of the PCM connectors is missing seals and a plastic color piece. I would consider this a parts source harness if you need some wire or plugs, but with some work it could be made to work on a Gen 3 motor. I ended up using an LS1 harness. All injector & coil plugs and most other sensor plugs are OK.
Wire harness pic 2003 LM7 (5.3) wiring harness $50
The plug for the crank sensor was cut off but is included. There are a bunch of wires that were cut (looks like they went to the fuse panel). One of the PCM connectors is missing seals and a plastic color piece. I would consider this a parts source harness if you need some wire or plugs, but with some work it could be made to work on a Gen 3 motor. I ended up using an LS1 harness. All injector & coil plugs and most other sensor plugs are OK.