GMPP Controllers and readiness codes
05-01-2009, 05:39 PM
#1
Teching In
Thread Starter
Join Date: May 2009
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
GMPP Controllers and readiness codes I am putting an LS7 into a car I am building. I plan to use the GMPP LS7 controller kit, and need to be able to pass emissions. Emissions in my state means scanning the ODB2 port with no MIL on, and a valid readiness code.
My engine will be clean, with cats, etc, but it needs to show a readiness code for inspection..
So: Does the GMPP LS7 controller set readiness codes?
I won't have the car ready to run for some time, so I can't just try it and see- and I need to know this sooner rather than later, so I can plan for contingencies.
Thanks!
My engine will be clean, with cats, etc, but it needs to show a readiness code for inspection..
So: Does the GMPP LS7 controller set readiness codes?
I won't have the car ready to run for some time, so I can't just try it and see- and I need to know this sooner rather than later, so I can plan for contingencies.
Thanks!
