flintwrench69

iTrader: (11)

I got my LC-1 connected to the car & its working. I connected the brown wire from the LC-1 to pin #1, I guess its the a/d pin to the far left does that sound right? I logged a few scans last night & the WB reading isnt there. Do I need to connect a ground also? My HPTuners box didnt come with a schematic for the a/d inputs 1-8. Is #1 to the far left? Also, the wiring directions in HPTuners for the LC-1 shows the 7 wire with the green analog ground, my LC-1 is missing that wire, only a 6 wire setup. Thanks.

darkhorizon

In the help file there is a diagram of what goes were. You need the ground hooked up as well.

flintwrench69

iTrader: (11)

Yea I found the diagram in the help file. The 8 pin connector that came with mine doesnt have any wires, just ports with wire clamps to put your own wires in there. I am thinking it should work if I run a ground, thanks.

flintwrench69

iTrader: (11)

I found the pin layout for the HPTuners unit that I have in the help section. I had the WB analog wired correct, to pin1. I had to go into the inputs & select LC-1. After I did that it worked & without running the ground wire.