Whos using a Innovative LC-1 with HPT Pro?
#1
TECH Resident
Thread Starter
iTrader: (12)
Join Date: Jul 2005
Posts: 765
Likes: 0
Received 0 Likes
on
0 Posts
Whos using a Innovative LC-1 with HPT Pro?
I'm ordering my LC-1 wideband this week and was wondering how much of a PITA it was to hook into your HP Tuners pro box. I am going to also have it wired into my a pillar gauge to use all the time. Is there a separate set or wires that you maybe roll up and put in the glove box or something that you can hook up to the box and still use the a pillar gauge? I'm kinda confused at how all this hooks up to be honest. Any pics or advice on how this instals would be much appreciated!
#2
TECH Fanatic
Mine works! Theres a small cable that has a yellow wire that go to the box, and ground the other. It has a small jack to be used for tunning also. I use the yellow wire, my in dash gauge works all the time.
#4
TECH Resident
Thread Starter
iTrader: (12)
Join Date: Jul 2005
Posts: 765
Likes: 0
Received 0 Likes
on
0 Posts
Pretty simple install? So you have your gauge installed permanatly as well as a separate set of wires in your glove box when you want to hook it up to log afr on HPT when you want correct? Did you have to buy any separate harnesses of wires other than what already comes with the LC-1?
#5
I have an LC1 running an A/F gauge full time and a separate set of wires i use to connect to the HPtuners too.
No separate harness needed.
The LC1 has two outputs. I used one or the gauge and one for the HPT.
No separate harness needed.
The LC1 has two outputs. I used one or the gauge and one for the HPT.
#7
TECH Fanatic
Pretty simple install? So you have your gauge installed permanatly as well as a separate set of wires in your glove box when you want to hook it up to log afr on HPT when you want correct? Did you have to buy any separate harnesses of wires other than what already comes with the LC-1?