What happens if you set switch 3 on MAFT to on?
#1
On The Tree
Thread Starter
Join Date: Nov 2002
Location: Newfoundland, Canada
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
What happens if you set switch 3 on MAFT to on?
I just checked my MAFT settings and I didn't realize it but switch 3 was set to on. It has been like this for a while and the car seems to run fine. Should I leave it alone or set it to off? Does it hurt any to leave it set to on? Soon getting tuning software but for now the MAFT works fine.
#4
On The Tree
Thread Starter
Join Date: Nov 2002
Location: Newfoundland, Canada
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
The Ramchargers site is down since couple of days so I can't get to ask them. I think the car runs fine, idles a little rough but the hotcam is known for that. Not sure if I should turn it to off or just leave it alone.??
#5
TECH Enthusiast
Join Date: Jan 2003
Location: Birmingham, AL
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
One dip switch is for v6 or v8, one is unused, and one is if you've got a GN. Don't remember the fourth. If only that one is different, make 'em all the same. I doubt it matters though.