Anyone have pics on how they ran their LC-1 through the car??
#1
TECH Enthusiast
Thread Starter
Join Date: Oct 2002
Location: NJ
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
Anyone have pics on how they ran their LC-1 through the car??
Just tring to figure out how to hook everything up in my car. Have all the wiring diagrams, just need to know where I can route the wires, and would like to know where ppl are putting the unit, how they are running everything through, etc. And are you using extra cable to keep the LC-1 cable in tact?
I've heard of the drivers floor board grommit. No problem their, just pushes the unit back a bit.
BTW, I will install in stock o2 on drivers side.
I've heard of the drivers floor board grommit. No problem their, just pushes the unit back a bit.
BTW, I will install in stock o2 on drivers side.
#2
TECH Addict
iTrader: (6)
I cut a slot in the drivers side grommet that comes out under the seat. It work well. I wished I did not have to keep the unit under the car. I have the unit strapped down to my SFC. I connected to a ground which is right by the drive seat and also used the pink power wire that also runs along the drive seat. I have my flashscan unit under the driver seat and just plug it into mu notebook when needed. It works great.
Good luck.
Bill
Good luck.
Bill