P0332 after header install
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: KY
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
P0332 after header install
I just finished installing my Pacesetter headers and TSP Y pipe. Problem is, the car is now throwing a knock sensor code (P0332 Knock Sensor 2 Circuit Low Input). This seems to be a result of the Y pipe banging the floorboard. My question is, since the banging is only very rare, will the code constantly pull timing until it is cleared or does it only pull timing when the "knock" is occuring? I am going to try and get the banging to stop, but really it isnt that bad. I just dont want to drive around with timing being pulled constantly.
#5
On The Tree
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: KY
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
The "noise" of the Y pipe banging can cause the knock sensors to trip. The knock sensors are nothing more than microphones basically. If they hear a loud banging noise, they can confuse that with knock.
#6
TECH Addict
Join Date: Jun 2002
Location: Las Vegas, NV
Posts: 2,428
Likes: 0
Received 0 Likes
on
0 Posts
The knock sensors pulling timing and throwing a code are different animals. If it was your y-pipe banging, you might have timing pulled but no code. The code means your KS is bad.
Last edited by Predator; 07-28-2006 at 06:26 AM.