AINT SKEERED

iTrader: (2)

I just purchased an lm1 and need to hook it to my efi live to do auto ve and cant find what I need to do. any help or hints would be greatfull. thanks

GM_POWER

iTrader: (5)

Try this:

http://download2.efilive.com/Tutoria...20Tutorial.pdf

http://download2.efilive.com/Tutoria...20Tutorial.pdf

AINT SKEERED

iTrader: (2)

I am using the Lm1 not the lc1. can you hook up a wide band without touching the nbo2's?

I have bungs in my exh. for a wide band with out touching the narrow band.

2002_Z28_Six_Speed

iTrader: (19)

Here is your check list.

Wire up LM1.
Perform free air calc.
Make custom PID in EFI-Life for your settings.
Set up LM1 with computer for those settings.
Hook up EFI Life, monitor the new PID, and record.

You are done.

I made this complete guide a long time ago but everyone ignored it.
https://ls1tech.com/forums/showthrea...733&highlight=

It will answer all your questions.

AINT SKEERED

iTrader: (2)

Thanks man. I will see if i can figure it out tomorrow. I think I understand but unitll I look at it on my setup , I am a little lost. I will check it out though.

2002_Z28_Six_Speed

iTrader: (19)

Well since you did get the LM1 (built in screen) worst come to worst you can have a buddy watch the screen.

Ask away whenever you get around to it.

AINT SKEERED

iTrader: (2)

That is what I have been doing but to dial in the ve table , you need it to work together to show where i am off through out.