I have a tsp 231/237 .598/.595 112+2 cam for sale. The cam is in perfect condition and has been used for just under 5,000 miles. Made 411rwhp mustang dyno 440rwhp dynojet with patriot heads and ls6 intake. Great cam with really good street manners. i will have some pics up tomorrow.

Now $255 Shipped to your door.

Pics of the cam and the cam card can be found here:

http://community.webshots.com/album/559131810qwEVSN

 

Will let it go for $280 shipped

 

how did it sound? was it very lopey?

 

just curious, what 1/4 mile ET's did it run, or do you know? i've got Speed Inc.'s SI5 in my car but haven't run it yet. it's almost identical, just a little less intake lift....thanks

 

it sounded pretty lopey. Lopier than my buddies 224/228. but it idled great and never had any driveability problems, like bucking or low rpms surging. Here is a link to how it idles and revs with my old 4'' catback. This video is old, hope it works.

http://video.ls1tech.com/search/231%...4d0f55aaf7.htm

I went to the track once and ran a 12.1@118 with a 2.0 60 foot, comming off the line just like any old start except slipping the clutch at 1800 rpms because i didnt want to break the rear. not sure what the 1/8 time was but it was aweful for running a 12.1@118. My buddy runs 11.9@115 in his car and i pull him all day long on the street si know it would have gone easy mid 11's and this was on street tires not using the 315 drag radials i have now

 

................

 

I have a set of stock heads, stock cam, and stock exhaust maniolfds off of a 1999 Z28. They all have about 30,000 miles and the heads dont have any valves or springs. They are in great condition.

Asking $150 plus shipping for the heads.

$30 plus shipping for the cam

$40 plus shipping for the exhaust manifolds

 

sent you a pm

 

pm replied to

 

I have he same heads and cam, so I can vouch for it. Nice setup, but hes making more power than I did. TTT for ya.

 

New price of $255 Shipped!!

 

pm sent

 

I have this same setup and my car made 449rwhp with the Patriot 6.0 heads. Here is a video of mine idling

http://video.ls1tech.com/video/wm/de...3a014797c0.htm

Bump for a nice cam

 

PM sent

 

pm's have been replied to. Thanks a lot for the video WS6. I had a video clip of mine on theinternet but i dont think it was working and everyone has been asking about one so you really helped me out.

 

Is it just the cam by itself? Or do you include retainers,pushrods,springs? etc.

 

pm sent.

 

Just the cam. Pms have been replied to.

 

CAM is SOLD