cant figure this one out
06-14-2012, 11:46 AM
#1
On The Tree
Thread Starter
Join Date: Feb 2012
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
cant figure this one out Hope this is the place to ask but here goes. Had my dash apart and noticed I had an old car alarm on it that didn't work anymore to I pulled it out along with all the wires. Now my electric door locks don't work. I was pretty careful when i pulled all the stuff out. Any ideas??
06-15-2012, 06:35 AM
#3
On The Tree
Thread Starter
Join Date: Feb 2012
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
I was really really careful Wun I pulled it out. Made sure not to cut any wires or anything. I pretty much just unclipped everything from the boxes and pulled the wires. There was one left tho that I couldn't find out where they went , maybe I.to the door somplace . I didn't cut them tho there just UN plegged from the unit under the dash on the drivers side
06-15-2012, 08:01 AM
#4
Gee, I had working locks and then I pulled out an alarm system (with keyless entry) and my locks don't work anymore. But that must be a coincidence because I was really careful pulling the alarm wires - the lock problem couldn't possibly be related to the wires I disconnected. 
Really?
Go back and check your door lock wiring connections... especially the orange with black and red with black wires going to the BCM.
Really?
Go back and check your door lock wiring connections... especially the orange with black and red with black wires going to the BCM.