1le rear lca bushing install . . .
#1
On The Tree
Thread Starter
iTrader: (6)
Join Date: Aug 2003
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
1le rear lca bushing install . . .
I bought some used lca's and drilled a few holes in the old rubber bushings and then hammered the old bushings out.
How do I install the new bushing, there are a few indentations along the outside of the lip and the inner part has a seam where the metal sleeve is rolled together. Any certain way these go in? Such as facing the lip vertical so as to avoid any horizontal pressure?
I attached a pic of the bushing, please look at it and advise.
How do I install the new bushing, there are a few indentations along the outside of the lip and the inner part has a seam where the metal sleeve is rolled together. Any certain way these go in? Such as facing the lip vertical so as to avoid any horizontal pressure?
I attached a pic of the bushing, please look at it and advise.
Last edited by ls1tech.fan; 01-11-2008 at 04:59 PM.
#3
On The Tree
Thread Starter
iTrader: (6)
Join Date: Aug 2003
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
I'm not asking how to do it . ..
Let me explain my question a little more:
Do I have to position the new 1le bushing in any certain way before I install it.
I was thinking the inner sleeve lip should face up or down so any force in this area doesn't gap it any. Maybe I'm being to critical?
Again . . is there a certain direction these are placed in?
!Please see pic!
Let me explain my question a little more:
Do I have to position the new 1le bushing in any certain way before I install it.
I was thinking the inner sleeve lip should face up or down so any force in this area doesn't gap it any. Maybe I'm being to critical?
Again . . is there a certain direction these are placed in?
!Please see pic!