Pro Kit rear and BMR front?
#1
Pro Kit rear and BMR front?
Has anybody done this? The back naturally sits a little higher as you all know, so I figured on the 1.3" pro kit in the back and the 1" BMR on the front should be a nice even drop? Am I thinking wrong? Anybody done this?
Thanks in advance!
Thanks in advance!
Last edited by Deerhunter-Z28; 08-20-2008 at 04:06 PM.
#2
TECH Senior Member
iTrader: (10)
Join Date: May 2005
Location: Bossier city,LA barksdale AFB
Posts: 5,353
Likes: 0
Received 2 Likes
on
2 Posts
pro kit drops the rear over 1.5"! They are not accurate at all. So if you did that it would sag i nthe rear really bad. Even if you get the pro it all the way around it will sag in the rear unless you add a hose around your top coil spring and keep the rubber isolators in to raise the rear up a little. BMR all the way around is a great look and level and DMS springs sit up in the rear a little but of you add a rubber hose around the top of the coil spring and remove the rubber isolator it will lower the rear just right! like this
Last edited by SIC LSX; 08-20-2008 at 04:52 PM.