94 teal formula Lt1 with lots of parts for sale
12-17-2005, 06:51 PM
#1
11 Second Club
Thread Starter
iTrader: (17)
Join Date: Dec 2004
Location: Kingwood, tx
Posts: 556
Likes: 0
Received 0 Likes
on
0 Posts
94 teal formula Lt1 with lots of parts for sale Like it says above I have a 1994 Formula for sale. Lt1 with 148,000 original miles. Has the following mods:
15x8 rear Drag lites with 5 1/2 bs. with ET streets that you might want to replace cause of a plug from a nail.
15x4 Drag lite runners with good tires
Rims still look new.
Mosier 12bolt painted viper red. 33 spline axles. TA Cover
BMR chrome molley Panhard bar and Lower Control arms
Ls1 Aluminum Driveshaft
Custom Nitrous kit: Wet kit with NOS Proshot solenoids. Nos Purge. 2 NOS dual black nozzels. Custom Billet Aluminum Nitrous Bottle bracket. Carbon Fiber guage mounted in dash. Nos Bottle Warmer.
BMR battery relocation kit.
Optima redtop battery.
Billingsley air conditioning delete plate.
Hypertech Power Programmer
New GM T-56 6speed with 5k miles or less.
New SPEC star stage 3 clutch with 400 miles or so.
MSD Digital 6
MSD Coil
16 inch electric fan
Afco Aluminum 4core radiator
1 3/4 Hooker longtubes
Brand new 3inch Dynomax race mufflers
52mm Edelbrock Throttlebody
Taylor 8mm wires
Madman lower Alternator relocation bracket
Kirkey aluminum racing seat
Lingenfelter chrome CAI
High flow bellow
Jazz Overflow Can
2brand new headlight motors
The water pump and Opti have been replaced a couple of years ago.
Now for a run down of the car. I have owned this car since about 1997 . I have put most all of the miles on this car. The tranny went out and I bought a brand new one from GM. The tranny has about 4-5k miles. I then stepped up to a the mosier 12bolt. It has about 3-4k miles. The nitrous kit has had about 6-7 bottle through it as well as the car. Just as I was getting the car all together I was hit by a drunk driver on the front drivers side. I left the car sitting for about a year or more. I finally had the body fixed and completely repainted. I then gutted the ac, power stearing, carpet, seats, and everything behind the dash. The car will run and drive, but still needs the driver side spindle and A-Arm replaced. I have those as well, I just have to go get them. Untill they are replaced the car pulls to one side. I have wired up everthing and everything works. The car does need some finishing, but most of it is minor. The mufflers are brand new and have not been bolted up yet. Some of the wiring needs to be pulled tight. Also Im sure you would notice, but the passenger side mirror is not bolted on. My dad tried moving it by the mirror...lol... but the mirror is fine,it just needs a bracket now. Here are some pics. Remember the car has been sitting a while and some parts are still dirty.(under the hood and under the car)
I am in the process of building a Harley so I am selling this for some extra money, otherwise I wouldnt be selling it at all. If you have any questions I didnt answer let me know. $6000. The rear and tranny take up alot of that so I think its a really good deal.
15x8 rear Drag lites with 5 1/2 bs. with ET streets that you might want to replace cause of a plug from a nail.
15x4 Drag lite runners with good tires
Rims still look new.
Mosier 12bolt painted viper red. 33 spline axles. TA Cover
BMR chrome molley Panhard bar and Lower Control arms
Ls1 Aluminum Driveshaft
Custom Nitrous kit: Wet kit with NOS Proshot solenoids. Nos Purge. 2 NOS dual black nozzels. Custom Billet Aluminum Nitrous Bottle bracket. Carbon Fiber guage mounted in dash. Nos Bottle Warmer.
BMR battery relocation kit.
Optima redtop battery.
Billingsley air conditioning delete plate.
Hypertech Power Programmer
New GM T-56 6speed with 5k miles or less.
New SPEC star stage 3 clutch with 400 miles or so.
MSD Digital 6
MSD Coil
16 inch electric fan
Afco Aluminum 4core radiator
1 3/4 Hooker longtubes
Brand new 3inch Dynomax race mufflers
52mm Edelbrock Throttlebody
Taylor 8mm wires
Madman lower Alternator relocation bracket
Kirkey aluminum racing seat
Lingenfelter chrome CAI
High flow bellow
Jazz Overflow Can
2brand new headlight motors
The water pump and Opti have been replaced a couple of years ago.
Now for a run down of the car. I have owned this car since about 1997 . I have put most all of the miles on this car. The tranny went out and I bought a brand new one from GM. The tranny has about 4-5k miles. I then stepped up to a the mosier 12bolt. It has about 3-4k miles. The nitrous kit has had about 6-7 bottle through it as well as the car. Just as I was getting the car all together I was hit by a drunk driver on the front drivers side. I left the car sitting for about a year or more. I finally had the body fixed and completely repainted. I then gutted the ac, power stearing, carpet, seats, and everything behind the dash. The car will run and drive, but still needs the driver side spindle and A-Arm replaced. I have those as well, I just have to go get them. Untill they are replaced the car pulls to one side. I have wired up everthing and everything works. The car does need some finishing, but most of it is minor. The mufflers are brand new and have not been bolted up yet. Some of the wiring needs to be pulled tight. Also Im sure you would notice, but the passenger side mirror is not bolted on. My dad tried moving it by the mirror...lol... but the mirror is fine,it just needs a bracket now. Here are some pics. Remember the car has been sitting a while and some parts are still dirty.(under the hood and under the car)
I am in the process of building a Harley so I am selling this for some extra money, otherwise I wouldnt be selling it at all. If you have any questions I didnt answer let me know. $6000. The rear and tranny take up alot of that so I think its a really good deal.
