01WS6/tamu

iTrader: (37)

I know this sounds odd especially here. But after looking in at modmotor tech no one ever reply's to posts it seems. I got a 99 4.6 gt that came in the shop today. One of our longtime customers bought it a few days ago. It has a ken bell blower headers and a few other goodies. I got a lean bank one and two dtc and it falls on it's *** as soon as boost starts to build. Fuel pressure is right at 55 lbs. I suspect it's a MAF it acts like a few other fords I have had come in and the maf has been bad. The HZ readings are a little low compared to a 4.6 truck I compared it to. Any ideas? Or do you just for my info know how many lbs/hr the stock injectors are? Thanks guys.

dan03mach

iTrader: (1)

Need to make some runs and data log them.. That will tell you what is going on..

01WS6/tamu

iTrader: (37)

Thanks I was planning on trying some logging later tomorrow evening. We have a ford wds it's just a pain in the *** to use. It's not near as user friendly as a tech 2. Then again I'm still learning a lot about it we've only had it for a few months. It beast the hell out of our old NGS though. Anyone know what size the injectors are. I have a project I may try to use a set of 4.6 injectors in they look like they will fit perfect.

POC

iTrader: (7)

Id find a good mustang board and start PMing people that have kenny bells.

01WS6/tamu

iTrader: (37)

I figured I'd try here I've seen a few people in and out of posts around here that have em. Guess I'll try later. Going down to the shop in a few minutes to do some logging and tinkering.

dan03mach

iTrader: (1)

On a GT the injectors are 19lb on a 99, 01 Cobra or Mach1 they are 24lb

SSilverSSurfer

iTrader: (8)

damn chris thats here in town?