1978 Malibu 25.5 Chassis roller fs or Trade
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: Oct 2006
Location: burbs of detroit
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
1978 Malibu 25.5 Chassis roller fs or Trade
Year: 1978
Make: Chevrolet
Model: Malibu
Price: $9000
Mileage: 1
Private or Dealer Listing: Private Listing
Location (State): MI
Color: Green
Transmission: Automatic
Drivetrain: Rear Wheel Drive
$9000.00 obo willing to trade roller for 98-02 SS/Z28 6 speed car, preferably a convertible, with little to no mods, no race cars.
also have parts to build 540 bbc and will sell as package if buyer is interested.
Pro Race Craft Engineering built 25.5 chassis, finished last year
Car has been mini tubbed with competition engineering 36 in wheel tubs
Frame has been notched and clearanced to fit M/T 29.5/10.5
12 bolt chevelle rear end (from a 1969) with moser axles, and strange light weight spool. 4:33 gears
Glasstech fiberglass front and rear bumpers
Harwood 6 inch outlaw lift off hood, drilled for hood pins, which are installed
All interior plastics are included, as well as rear seat, which is rough and could be recovered, and reinstalled after side foams are trimmed for fully functional back seat look.
1 Kirkey pro street drag seat, 18 or 19 inch, cant remember
Interior is completely gutted, and ready for race car wiring, no dash, was cracked terribly.
25.5 cage and every bar has 3 coats of VHT satin roll cage paint on it, ($100 in paint alone)
Needs fresh paint, LH ¼ panel dent bumped out from racing pre cage without anti roll bar, (small dent)
LH ¼ has small amount of rust at wheel well on bottom, minor.
Car has paint chips here and there as its 20 plus years old.
Car is setup for BBC with motor plate.
TNT raceshop alum. CNC cut motorplate for Gbody
Chassis engineering midplate
Hooker Supercomp 2241 BBC G-body headers with slip tubes
Frame has been painted, wire wheeled, and had a fewbody mount holes repaired by the Fab Shop, also had inner frame rail boxed. Frame is amazing, and one of the cleanest frames on a gbody I’ve seen, I pulled the factory frame out cause it was rusty, and broke in one spot when I bought the car.
TNT raceshop alum body mount bushing+ 25.5 cage is about is ridged as I could make the chassis
Moroso front tires with Weld prostars, rear is a Prostar knock off
Car comes with 29.5x10.5’s (m/t) and 29. True tens (hooser)
Electrical
All factory wiring has been removed and bagged so car can be wired to be race car, its all included with the car, all harnesses and fuse blocks
no tire kickers, or time wasters. Lost interest in car, and am focusing on degree and other priorities,an not hard up for cash.
Last edited by erskine; 08-23-2014 at 02:25 PM.