ironexecutioner

Looking for a 98+ M6 Camaro Heavily modded with a Supercharger and a completely built motor. Looking to have at least a 12 bolt moser rear. PM me details and price. Thanks a lot.

RyanLHarris

bump. im looking for the same thing

RyanLHarris

ttttttttt

Paul F

iTrader: (2)

Here ya go. No supercharger but the motor is built for heavy nitrous or with a head swap to lower compression I supercharger would be great. I'll have some good pics in a few days if you are interested. $20K.

Engine

Katech Resleeved LS1 Block (4.060 Bore) (can go to 4.100)
Katech Billet Main Caps
ARP Main Studs
ARP Head Studs
New Stock Crank
Oliver Billet CM Rods
Diamond Custom Nitrous Pistons
Diamond Piston Rings
GTP Stage III LS6 Custom Ported Heads (flowed over 337cfms)
Custom Ferrea SS 2.100 / 1.60 Valves
T&D Shaft Mount Rocker Arms
Comp Cams Valve Springs
Manley Ultra Light Titanium Retainers
Manley Titanium Valve Locks
Comp Cams CM 1 piece Pushrods
Thunder Racing Custom Solid Roller Camshaft
Cloys Hex-Adjust Timing Set
C5R Timing Chain Dampener
Ported and Blueprinted LS6 Oil Pump
LS6 Intake
TR Ported TB
Katech Cast Al. Valve Covers
Katech Coil Relocation Kit w/ Plug Wires
Motor Completely Balanced and Blueprinted


Drivetrain

Spec Stage IV-F Clutch
Spec Al. Flywheel
McLeod Adj. Clutch Master Cylinder
Stock GM T-56 Transmission
Hurst Chrome Stick Shifter
Moser 9” Rearend
- Detroit Locker
- 35 Spline Gundrilled Axles
- Al. Center Section
- 4 ch. ABS brakes w/ Traction Control
- 4.30 gears
- Narrowed 2.5”
Centerline Convo Pro Wheels
- 15” x 3.5” Front w/ 195/R15 tires
- 15” x 8.5” Rear w/ MT 275/50/15 ET Street Radials




Suspension

Front
- BMR Tubular K-member
- BMR Upper & Lower Tubular A-arms
- BMR Strut Tower Brace
Rear
- BMR 1” Lowering Springs
- BMR Adj. Xtreme Duty Control Arms
- BMR Adj. Panhard Rod
- BMR Adj. Tubular Torque Arm
- QA1 12-Way Adj. Shocks

Exhaust

TR 1 7/8” Long Tube Headers Ceramic Coated
Mufflex 3” Y-pipe w/ 4” Collector
Magnaflow Catback Exhaust System

Brakes

Powerslot Slotted Rotors (Front & Rear)
Hawk HPS Brake Pads (Front & Rear)

General

Factory Hugger Orange Paint
Tan Leather Interior
T-Tops
SLP Ultra-Z Ram Air Hood
- Custom Painted Hugger Orange w/ “Ram Air” & Black Stripes
SLP Bow Tie Grill
Rear Light Panel Custom Painted Black
Factory A/C & Power Steering
46,000 miles
6-point Bolt-in CM Roll Bar w/ Dual Swing-out (not installed)