Typical H/C Junk
#24
12 Second Club
iTrader: (14)
Join Date: Aug 2007
Location: Brighton, CO
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
congrats on the runs, very nice times. I have the same gearing and converter as you, but with a 26" hoosier. I thought that the bigger tire would slow you down in that combo, am I way off here?
#25
1.55 60'
7.10 1/8
96.28 mph
11.19 1/4
119.61 mph
The only changes I made from then until now were that I went to a bigger FTP lid with an 85mm MAF, added a u/d pulley, and removed the a/c. The car gained 20rwhp and as you can see it trapped 3.39mph higher even with the taller tire.
#28
9 Second Club
iTrader: (4)
Def nice running car! You have a very similar cam that I have in my Formula. Ours is a LSL lobe 235/243 112+2. Ours being lower compression on stock 241 LS1 heads is really hurting this camshaft I believe. It made 396rwhp and has run a best of 11.7@116 so far but the stock tranny gave in on that 11.7 pass. 4k Circle D stall aided in that I'm sure haha.
Congrats on the 10's! That's flying in a stock bottom end full weight car.
Congrats on the 10's! That's flying in a stock bottom end full weight car.
#30
9 Second Club
iTrader: (4)
Keep up the good work!
#32
I did very minor mods from then until now, just went over everything a second time and caught a few little problems. One of which was a dragging set of rear brakes, car tapped the limiter on the 1-2 shift as well, and removed some weight. Couldn't believe it gained 20hp from a lid and u/d pulley so that was a bonus.
#39
it very well could have been, that day didn't necessarily start out how I had planned wish I could have done a few things before leaving. Here is a go pro vid of an 11.19 pass so this isn't a meaningless post.
http://youtu.be/ettqi0muQFg
http://youtu.be/ettqi0muQFg