12.89@109 with 1.9 60 ft
 

first time at the track i ran a 13.3@104 and i got it down to 12.89@109 with some slight modification to air box, k and filter, and half tank instead of a full tank. it has basic bolt, passetter headers off road y pipe and hooker cb with no cats,k and n filter, and shift kit in the trans.
i need some new rear lower control arms and were wondering what company you guys would recommend i was thinking bmr

What year is your LS1? Awesome ETs man, especially for your first visit!!

That looks like GLD where you from?

good run

its a 98 and im from northern illinois i got to union grove in wisconsin

Not bad at all for the mods! My 98 only ran 12.75 at 109 with a stall, headers, lots of suspension, intake, tune, cat-back... and a 1.75 60'. So you're right where you should be.

I like Sphoon suspension parts, but BMR is awesome shat too. Can't go wrong with either.

yeah i want to put 275's in the rear with 3.73 rear end, heads, cam, fast intake, and magnaflow cat back

check out Founders Performance. They are a sponsor on here. As well as, an up and coming company. I have seen many people on here who seem to be satisfied with the company and their parts. I plan on ordering some of theit LCA's and panhard bar after the new year. Hope this helps
Spencer

Their lca relo brackets helped shave 2 tenths off of my 60ft...

Re-location lca work and get the torque arm too

wait, what? You mean 2 whole tenths of a second... as in going from something like a 1.8 to 1.6 60'??? Man, now that I have my LCA relocation brackets I need to get back to the track to run my car again...

To the OP: I know they're not a sponser, but I have Lakewood LCA's. They're nonadjustable, but were only $99 from JEGS. Yet, you can't really go wrong with BMR or UMI :)