12.89@109 with 1.9 60 ft
#1
Teching In
Thread Starter
Join Date: Nov 2011
Location: northern illinois
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
12.89@109 with 1.9 60 ft
first time at the track i ran a 13.3@104 and i got it down to 12.89@109 with some slight modification to air box, k and filter, and half tank instead of a full tank. it has basic bolt, passetter headers off road y pipe and hooker cb with no cats,k and n filter, and shift kit in the trans.
i need some new rear lower control arms and were wondering what company you guys would recommend i was thinking bmr
i need some new rear lower control arms and were wondering what company you guys would recommend i was thinking bmr
#6
TECH Apprentice
iTrader: (2)
Join Date: Mar 2007
Location: Raleigh, NC
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
Not bad at all for the mods! My 98 only ran 12.75 at 109 with a stall, headers, lots of suspension, intake, tune, cat-back... and a 1.75 60'. So you're right where you should be.
I like Sphoon suspension parts, but BMR is awesome shat too. Can't go wrong with either.
I like Sphoon suspension parts, but BMR is awesome shat too. Can't go wrong with either.
Trending Topics
#8
Teching In
iTrader: (1)
Join Date: Dec 2010
Location: North Dallas
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
check out Founders Performance. They are a sponsor on here. As well as, an up and coming company. I have seen many people on here who seem to be satisfied with the company and their parts. I plan on ordering some of theit LCA's and panhard bar after the new year. Hope this helps
Spencer
Spencer
#9
12 Second Club
iTrader: (2)
Join Date: Jan 2011
Location: Old Bridge, NJ/Corpus Christi, TX
Posts: 1,215
Likes: 0
Received 1 Like
on
1 Post
check out Founders Performance. They are a sponsor on here. As well as, an up and coming company. I have seen many people on here who seem to be satisfied with the company and their parts. I plan on ordering some of theit LCA's and panhard bar after the new year. Hope this helps
Spencer
Spencer
#11
Launching!
iTrader: (3)
Join Date: Apr 2008
Location: FL
Posts: 223
Likes: 0
Received 0 Likes
on
0 Posts
wait, what? You mean 2 whole tenths of a second... as in going from something like a 1.8 to 1.6 60'??? Man, now that I have my LCA relocation brackets I need to get back to the track to run my car again...
To the OP: I know they're not a sponser, but I have Lakewood LCA's. They're nonadjustable, but were only $99 from JEGS. Yet, you can't really go wrong with BMR or UMI
To the OP: I know they're not a sponser, but I have Lakewood LCA's. They're nonadjustable, but were only $99 from JEGS. Yet, you can't really go wrong with BMR or UMI