TRANS AM emblems slanted
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 363
Likes: 0
From: Bolingbrook, IL
TRANS AM emblems slanted Ok I got the old ones off and the new ones on..They look good but I they are a little slanted, so my question is can I take the hair dryer to the emblem again to heat it up so I can slide the letters up or down? Has anyone ran into this problem as well, and how did you fix it..Thanks everyone...
!Dial-up Director
Joined: Nov 2001
Posts: 3,100
Likes: 1
From: Louisiana
Re: TRANS AM emblems slanted Here is what I did..
I had the measurements from the body shop on where they are positioned on the door exactly. Measured it out and marked it with a pencil. Then take masking tape and box in the area that the emblems go. Use a small level to make sure you have the tape level. Do that, and I think you will pleased with the results. <img src="gr_stretch.gif" border="0">
Justin
I had the measurements from the body shop on where they are positioned on the door exactly. Measured it out and marked it with a pencil. Then take masking tape and box in the area that the emblems go. Use a small level to make sure you have the tape level. Do that, and I think you will pleased with the results. <img src="gr_stretch.gif" border="0">
Justin
TECH Senior Member
Joined: Nov 2001
Posts: 11,603
Likes: 0
From: Chi-Town, IL
Re: TRANS AM emblems slanted Yea you can take the hair dryer to them again I guess.....if they don't stick to well go get some new sticky tape... <img src="gr_stretch.gif" border="0">
Thread Starter
TECH Apprentice
Joined: Nov 2001
Posts: 363
Likes: 0
From: Bolingbrook, IL
Re: TRANS AM emblems slanted Good thinking...I had someone look at them yesterday and they were unable to tell that they were slanted a little, so I am just going to leave them. In our minds its never perfect but we are the only ones who know the truth <img src="gr_images/icons/wink.gif" border="0"> Wish I wouls have thought about that earlier, but that was a great idea Justian
Re: TRANS AM emblems slanted Wouldn't use level unless where you're
parked is level.Concrete slopes for drainage
Better off measuring then draw line.
IMHO <img src="gr_grin.gif" border="0">
[ January 30, 2002: Message edited by: las vegas hawk ]</p>
parked is level.Concrete slopes for drainage
Better off measuring then draw line.
IMHO <img src="gr_grin.gif" border="0">
[ January 30, 2002: Message edited by: las vegas hawk ]</p>
