Fast92 - Shaved/Smoothed/Painted
Thanks everyone!!!
If you add everything up the cost is about $3200.
Good thing is, I'm a web designer and traded website work for most of the parts. I have about $800 in that setup.
Yea me too. I did some test fitting before I had it painted and adjusted a few things to keep it from rubbing. It will still be close. I have a few other ideas to keep it from rubbing. Fingers crossed.
Good thing is, I'm a web designer and traded website work for most of the parts. I have about $800 in that setup.Yea me too. I did some test fitting before I had it painted and adjusted a few things to keep it from rubbing. It will still be close. I have a few other ideas to keep it from rubbing. Fingers crossed.
Cool..Keep me updated if you can. When i get a FAST setup i want to go with that lid.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Thanks everyone!!!
If you add everything up the cost is about $3200. Good thing is, I'm a web designer and traded website work for most of the parts. I have about $800 in that setup.
Yea me too. I did some test fitting before I had it painted and adjusted a few things to keep it from rubbing. It will still be close. I have a few other ideas to keep it from rubbing. Fingers crossed.
If you add everything up the cost is about $3200.
Good thing is, I'm a web designer and traded website work for most of the parts. I have about $800 in that setup.Yea me too. I did some test fitting before I had it painted and adjusted a few things to keep it from rubbing. It will still be close. I have a few other ideas to keep it from rubbing. Fingers crossed.
. Doug did awesome work!
I have seen this done before and alot of work goes into doing this. But, I would have asked him to blend in the stock fuel rail indentations in the middle of the intake. Those dents just stand out to me. Here is a pic that has the indentation removed. Last edited by dgcustomz; Sep 18, 2010 at 10:33 PM.
Ok figured I'd update this old thread with install pics. Pretty much done. Just need to take care of some minor cleanup like the maf wiring and getting rid of the blue fittings on my catch can.
Pretty much done. Just need to take care of some minor cleanup like the maf wiring and getting rid of the blue fittings on my catch can. 