Trans Am Diffuser, CETA area, installed...
Thread Starter
Banned
iTrader: (56)
Joined: Jul 2004
Posts: 12,637
Likes: 4
From: Valley Village, CA
This was the first out of the mold. We told them to leave more material on all the rest. Customer might have to trim to fit a little but it will be a better fit in the end...
Thread Starter
Banned
iTrader: (56)
Joined: Jul 2004
Posts: 12,637
Likes: 4
From: Valley Village, CA
Would you like a fiberglass diffuser or a carbon fiber one? E-mail me your choice and your address to madelisle@yahoo.com and I'll let you know when to expect a gift in the mail 
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo Would you like a fiberglass diffuser or a carbon fiber one? E-mail me your choice and your address to madelisle@yahoo.com and I'll let you know when to expect a gift in the mail
Thread Starter
Banned
iTrader: (56)
Joined: Jul 2004
Posts: 12,637
Likes: 4
From: Valley Village, CA
I'd be all over this if it had a fin to delete the exhaust tips...I would be fighting with the wife over the money and prob sleep on the couch a night or two! But it doesn't and that's a bit much to pay for something to hack it all up to change it all. Sure does look awesome for those keeping rear exit tips!
Imagine making a diffuser for center exhaust..... Ya, for a TA. This diffuser is awesome, I wonder how a TA with center exhaust would look, I mean unfortunately you'd have to cut the rear bumper, but if a diffuser is added it would probably look sweet. Make the tail pipes more like the SLP.... Just a thought!
Nice work
Nice work
You could use vfn's rear bumper with wheelie bar cut out and use the motorized hideaway plate OR install the plate between the taillights and make a new filler in clear(or smoked) add and LED light stip and voila!
If I can make a clear filler that looks good would you consider tranforming that vfn bumper into a usable bolt on version?
If I can make a clear filler that looks good would you consider tranforming that vfn bumper into a usable bolt on version?
Thread Starter
Banned
iTrader: (56)
Joined: Jul 2004
Posts: 12,637
Likes: 4
From: Valley Village, CA
^^We thought about just making a CME diffuser, you cut your bumper and we supply a way to put plate between the tails but most people thought the attraction of the CME did NOT out weigh the unattractiveness of the plate between the tails... Too Third Gen.
