Dumb Question
#1
TECH Enthusiast
Thread Starter
iTrader: (87)
Join Date: Sep 2004
Location: Charleston, SC
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
Dumb Question
I am running a MAF-less tune and would like to lose the MAF. I know guys out there are running a straight piece of rubber hosing, but don't know what/where to get it at.
Anyone that has done this please chime in and give me a helping hand.
Thanks, Mike
Anyone that has done this please chime in and give me a helping hand.
Thanks, Mike
#4
TECH Regular
iTrader: (28)
I did exactly what you're talking about. I don't know what TB & Lid you're running, so you might be slightly different from me. I was running a FTP 98mm lid and a Holley 90mm TB. The outside diameter was 4". I ran a 6" long tube from the lid to the TB with a little trimming on the top of the tube on the TB side to allow for the angle change.
Here is a pic:
Link for the tubes.
Here is a pic:
Link for the tubes.
Trending Topics
#12
TECH Enthusiast
Thread Starter
iTrader: (87)
Join Date: Sep 2004
Location: Charleston, SC
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
There is no simple answer bud, take a peak in the PCM section and like stated look up "Speed Density".
FERNCO is the thick rubber hosing you buy at Lowe's. I was looking for the thinner walled stuff.
Thanks for everything guys!