Better A/C knobs for T/A's
03-21-2005, 12:21 AM
#21
Originally Posted by 2MuchRiceMakesMeSick
Ive never seen anyone get so excited over *****.
I also got around to the headlight ****. Check it out:
A while back I decided to replace the AC ***** for better grip and that kinda got me thinking about the headlight **** as well. On some other cars the headlight **** is illuminated when the engine is on so you don't have to feel around for the headlight switch at night. I got used to it on another vehicle and wanted something similar for the TA.
Basically, I bought another **** just like the one I used for the AC, cut the shaft down considerably and glued it back on, mounted a small red LED in the ****. Drilled a hole into the **** area of the switch, ran wiring through the hole and then wired it up to ign. using a resistor. It's harder than it sounds, but works great.
Alright, here is the day shot.
Here is the night shot with the lights off but ignition on.
03-21-2005, 02:09 AM
#22
Teching In
Join Date: May 2004
Location: Andrews, Nc
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
I got some billet ***** off ebay and a white HVAC kit the white is alight out of place with a stock head unit but once I put in my DVD player it looked fine. Very attractive I also put hyperleds behind the ***** instead of the stock lights so the hole in the **** lights up the front of the HVAC control where the selection is. I've had a whole lot of complements on them. I’ve had several of my friends ask me to get the parts for their cars. So I don’t think its just my love of rice (the food rice that is). I would post some pics but my car is in the shop and I think it’s going to be there for an extended vacation. I’ll try to remember to take some pics when I go up there again.
hmm guess I've got some bulbs to replace lol 
12-05-2006, 12:41 PM
#29
Originally Posted by DirtyBird222
if i put red leds back there they are
Frankly, I didn't like the camaro *****.
12-05-2006, 01:58 PM
#33
wouldnt it be cool if the ***** could double as a gauge? like just be flat and round like stock but have grip on the outside so you grab it like a lid to a jar but on the front face was a gauge?And there could be bearing in between so the gauge stayed in the right position when you turned the ****? lol quick thought i just threw out there i dont know how cool it would really be!
